Novus 30
Novus 30 is a good quality compressed sheet material based on a blend of aramid and inorganic fibres with a nitrile rubber binder system.
Service
Novus 30 is a general purpose material suitable for use in a wide range of applications, including hot and cold water, steam, oils, fuels, gases and a wide range of general chemicals
Approvals / Compliance
| WRAS Potable Water: Registration No. 0008505 |
| Complies with BS Specification 7531 Grade Y |
Availability
| Standard sheet sizes (m): | 2.0 x 2.0 2.0 x 1.5 2.0 x 1.0 1.5 x 1.5 1.5 x 1.0 |
| Thickness range (mm): | 0.4 to 6.0 |
| Standard roll sizes (m): | 6.0 x 2.0 |
Available with fine mesh mild steel reinforcement: Novus 30 Metallic or gauze mild steel wire reinforcement: Novus 30 GWI.
It can also be supplied with anti-stick coating and graphite coating.
Physical properties
| Thickness | 1.5mm | |
| Density | 2.0g/cc | |
| Tensile Strength | ASTM F152 | 12MPa |
| Compression | ASTM F36 | 9% |
| Recovery | ASTM F36 | 50% min |
| Residual Stress | BS 7531 (300°C) DIN 52913 |
23MPa 29MPa |
| Gas Leakage | BS 7531 | <1.0cc/min |
| ASTM Oil 1 | Thickness Increase | 2.0% |
| IRM 903 Oil | Thickness Increase | 5.0% |
| ASTM Fuel B | Thickness Increase | 4.0% |
Novus 30 Pressure/Temperature Limits
1. Suitable subject to chemical compatibility.
2. Suitable in some cases but check your application requirements with Flexitallic.
3. Contact the Technical Team for applicatis on with higher temperatures and pressures. Applicable to 1.5mm and below.
The operating temperature of non-asbestos sheet material is related to the thickness of materials selected. Thinner materials give better temperature and pressure properties.
